![]() ![]() I'll have to double triple check the hubs I thought were 1979 to see if in fact they are or aren't. My problem was that I thought I had 1979 hubs and that's what I had planned to use, but once I kept having issues I switched over to my 1988 hubs and I think all 4 hubs are 86-91 ford. You will want Dorman 610-279 and it uses the 1/2x20 lug nut. Hubs for 1979 Ford dana 60 kingpin axle take a different stud and nut and the ones I bought were Dorman 610-300 and uses a 9/16x18 lug nut and Raybestos 6058B and uses a ½x20 lug nut and NEITHER are CORRECT due to knurl location. This solved my issue after buying the wrong ones 3 times. This is the same stud that Chevy uses on their 1986 K20 4x4 front axle that GubNi uses for his brake kit to change the ford brakes to chevy. Hubs for 86-91 ford dana 60 kingpin axle take Dorman 610-278 wheel studs. I have 2-3 options, thanks to chainsawron's link to that thread and doing a little searching-tomorrow I'll swing by Oreilly's return the ones and see if they have any of the the other options.may have to buy a drill bit though and drill out the hubs a little, but we shall see. ![]() I found the issue-the Dorman 610-300 knurl works in the hub, but it needs to be ½" -1" below the head and these aren't, so I just have to find a stud that has the knurl in that location with a shoulder to fit chevy rotor.on the hunt. Here's my experience with my '79 Ford hi-pin dana 60-good luck. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |